Setup a PC with a projector...

1. As shown below (Figure 1 and Figure 2) carefully unpack your projector. Please handle with care as it can sometimes be tricky to remove the projector from the case.

2. After removing the projector close the case and acquire the Power and VGA cables located in the zippered pouch on the front of the case (see Figure 3 for details).

3. Notice in Figure 4 there are two VGA ports on the projector a "MONITOR IN " and "MONITOR OUT ". The VGA cable supplied will be plugged into the "MONITOR IN " on the projector (see Figure 5 above). The other end of this cable will be plugged into the back of the computer being used. Carefully locate and unplug the VGA cable from the back of the computer and set it near the projector as it will be used there. Plug in the projector cable to the computer (see Figure 6 and Figure 7).

4. The VGA cable that was plugged in to the computer which comes from the monitor now gets plugged into the "MONITOR OUT " port on the projector.

5. Locate the supplied power cord and plug it into the port located on the side of the projector and the other end into an outlet or surge protector (see Figure 8 for location and Figure 8.1 for wiring completed).

6. You may adjust the height by pushing the button on the front of the projector. (See Figure 9) Lift the projector and push the button. A spring loaded foot will pop out of the bottom of the projector (see Figure 10). To adjust the height hold the button in and adjust height. When desired height is reached let go of the button. The height is now set.

7. Now locate the lens cover on the front of the projector and remove it (see Figure 11).

8. Now that all wiring is complete press the power button on the top of the projector to power it up. The projector will take a minute to warm up. When warm the projector will project what ever is being displayed on the computer.

9. Lastly always remember that the projector must cool down before you unplug it from the power source. The time it takes to cool down will be dependant on how long it was running. Press the power button twice to power it down and wait until the green power light blinks before unplugging it from the power source. Failure to follow this step decreases the life of the projector bulb thus making the projector useless.